GeoTesting Express is a provider of Geosynthetic Testing Services – ASTM D,Test Method for Bursting Strength of Textiles-Constant-Rate-of-Traverse. Standard Test Method for Bursting Strength of Textiles-Constant-Rate-of- Traverse (CRT) Ball Burst Test. Theory: ASTM D is used to determine the. ASTM D Standard Test Method for Bursting Strength of Textiles—Constant- Rate-of-Traverse (CRT) Ball Burst Test.

Author: Yonris Malazragore
Country: Belgium
Language: English (Spanish)
Genre: Education
Published (Last): 22 February 2007
Pages: 326
PDF File Size: 5.66 Mb
ePub File Size: 13.11 Mb
ISBN: 719-4-60212-695-5
Downloads: 50862
Price: Free* [*Free Regsitration Required]
Uploader: Mirr

Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

In cases of disagreement arising from differences in values reported by the purchaser and the seller when using Test Method D for acceptance testing, the statistical bias, if any, between the laboratory of the purchaser and the laboratory of the seller should be determined with comparison based on testing specimens randomly drawn from one sample of material of the type being evaluated.


It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. The test results from the two laboratories should be compared using a statistical test for unpaired data at a probability level chosen prior to the testing series.

Other materials with established test values may be used for this purpose. The kind of force transfer and strength that occur when knitted goods are worn is prevented by clamping them as directed in this test method. Combining values from the two systems may result in nonconformance within the specification.

Historical Version s – view previous versions of standard. The test samples used should be as homogeneous as possible, drawn from the material from which the disparate test results were obtained, and randomly assigned in equal numbers to the laboratories for testing.

If a bias is found, either the cause must be determined and corrected or future test results must be adjusted in consideration of astmm bias. The values stated in each system astk not exact equivalents; therefore, each system may be used independently of the other. Within the test, the inch-pound units are shown in parentheses.


ASTM D – Ball Burst Puncture Fixture

Link to Active This link will always route to the current Active version of the standard. This standard does not purport to address all of the safety concerns, if any, associated with its use.

Test Method D is considered satisfactory for acceptance testing of commercial shipments of textiles fabrics for bursting strength since the method has been used extensively in the trade for acceptance testing. For the measurement of bursting strength with a hydraulic testing machine, refer to Test Method D