Above values from ASTM A Higher strengths can be produced by heavy cold work – this may be required for certain applications. ASTM A – 16 Standard Specification for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging. This specification covers. See the chemical composition and physical properties of ASTM A Grade annealed Stainless Steel, find alternative materials, and connect with suppliers.

Author: Arashisar Faemi
Country: Oman
Language: English (Spanish)
Genre: Technology
Published (Last): 26 September 2006
Pages: 253
PDF File Size: 6.66 Mb
ePub File Size: 2.85 Mb
ISBN: 159-9-80872-568-2
Downloads: 29978
Price: Free* [*Free Regsitration Required]
Uploader: Kazilrajas

ASTM A for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging

Copyright ASTM Standard Specication for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging1 This standard is issued under the xed designation A ; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval.

  HIPERBOLIK FONKSIYONLAR PDF

A superscript epsilon e indicates an editorial change since the last asmt or reapproval. This standard has been approved for use by agencies of the Department of Defense.

The SI equivalents are in parentheses and may be approximate.

Such requirements may include, but are not limited to the following: General Requirements for Delivery 4. Current edition approved Jan.

ASTM A493 – 16

Originally published aastm A — Last previous edition A — NOTE 1—A typical ordering description is as follows: An electroplated copper coating is often used. The following coatings may be specied: Soap is generally used.

The following lubricants may be specied: B Product analysis tolerance over the maximum limit for carbon and nitrogen to be 0.

Material can be manufactured to tensile strength ranges other than those shown in Table 2. The producer should be consulted when material is required to tensile strength ranges other than those specied.

For smaller sizes, similar mechanical properties apply to ferritic and martensitic grades; however the producer should be consulted regarding somewhat higher tensile properties applicable to austenitic grades.

  JBOSS RICHFACES 3.3 PDF

Resistance to Intergranular Corrosion 8. Packaging and Package Marking 9.

The American Society for Testing and Materials takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard.

Users of this standard are expressly advised that determination of the validity a4993 any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility.

This standard is subject to revision at a4933 time by the responsible technical committee and must be reviewed every ve years and if not revised, either reapproved or withdrawn.

Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM Headquarters. Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend.