GeoTesting Express is a provider of Geosynthetic Testing Services – ASTM D,Test Method for Determining the (In-plane) Flow Rate per Unit Width and . ASTM D Test Method Determining the (in-plane) Flow Rate Per Unit Width and Hydraulic Transmissivity of a Geosynthetic Using a Constant Head. Last previous edition approved in as D – 2. For referenced ASTM standards, visit the ASTM website, , or contact ASTM Customer.
|Published (Last):||26 April 2014|
|PDF File Size:||12.34 Mb|
|ePub File Size:||20.80 Mb|
|Price:||Free* [*Free Regsitration Required]|
Features Diaphragmpressurizing High pressure, Keeping pressure long time, easy to maintain, can greatly reduce the testing cost. The test is intended primarily as an index test but can be used also as a performance test when the hydraulic gradients and specimen contact surfaces are selected by the user to model anticipated field conditions.
Send your message to this supplier. Your email address is incorrect!
The test specimens should then be randomly assigned in equal numbers to each laboratory for testing. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Combining values from the two systems may result in non-conformance with the standard. If bias is found, either its cause must be found and corrected or the purchaser and supplier must agree to interpret future test results in light of the known bias.
Competent statistical assistance is recommended for the investigation of bias. Historical Version s – view previous versions of standard. Recommended Quality Verified Suppliers. The average results from the two laboratories should be compared using the Student’s t -test for unpaired data and an acceptable probability level chosen by the two parties before the testing is begun. Enter your email please. Link to Active This link will always route to the current Active version of the standard.
The flow of water within the plane of a geotextile or geotextile-related product is measured under varying normal compressive stresses, with typical hydraulic gradients and with defined contact surfaces.
Inquiry Sent Successfully Confirmation email has been sent: Pressure Pump and Testing Cylinder Easy to operate, the result more accurate. D44716 Geotextile Water Flow Capacity Tester, to determing the constant-head water flow capacity within the plane of a geotextile or geotextile-related product.
Please reply me within 24 hours. Please reply me widthin 24 hours.
Site Member 3 Years. Geotextile Water Flow Capacity Tester, to determing the constant-head water flow capacity within the plane of a geotextile or geotextile-related product. Forward Filter Manufacturers Co. It is the responsibility of the user of this standard to establish appropriate safety atm health practices and determine the applicability of regulatory limitations prior to use.
As a minimum, the two asm should take a group of test specimens that are as homogenous as possible and that are formed from a lot of the material of the type in question.
Please enter 20 to characters to contact this supplier! I would like your verified suppliers matching service!
Your message has been sent to the following suppliers. Comparative tests as directed in 5. Your message must be betweencharacters!
The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.
For the best results, we recommend including the following details: