F37 – 00 Standard Test Methods for Sealability of Gasket Materials, Gaskets, Leak testing-gasket materials, Sealability, sealability of gasket materials, test. ASTM F37 (Method A) Test Cell is used to evaluate the fluid sealing properties of gasket materials. ASTM F37 (Method A) Test Cell with Test Panel is the. ASTM F37 (Method B) Test Cell is used to evaluate the gas sealability of Cell with Test Panel is the complete assembly for the ASTM F37 (B) test method.

ASTM F37 – 06 Standard Test Methods for Sealability of Gasket Materials

It is the aatm of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Test Method A is restricted to liquid leakage measurements, whereas Test Method B may be used for both liquid and gas leakage measurements. This standard does not purport to address all of the safety concerns, if any, associated with its use. ICS Number Code The values in parentheses are for information only.

Active view current version of standard. Ast to Active This link will always route to the current Active version of the standard. The values in parentheses are for information only. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Test Method F is another sealability test method that uses a larger gasket specimen and higher internal pressures and flange loads. The test method may be used as an acceptance test when the producer and user have agreed to specific test conditions for the following parameters: For specific hazard or warning statements, or both, see 5.

Test Method A is restricted to liquid leakage measurements, whereas Test Method B may be used for both liquid and gas leakage measurements.

Test Adtm F is another sealability test method that uses a larger gasket specimen and higher internal pressures and flange astmm. For specific hazard or warning statements, or both, see 5. The test method may be used as an acceptance test when the producer and user have agreed to specific test conditions for the following parameters: Historical Version s – view previous versions of standard.

Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Link to Active This link will always route to the current Active version of the standard.

Holding a gasket material under load for extended time periods may give different results.