The Atmel AT89C52 is an based Fullly Static 24MHz CMOS controller Allen Systems; AT89C52 Controller Board Data Sheet for the Atmel AT89C AT89C52 8-bit Microcontroller With 8k Bytes Flash Features. Compatible with MCSTM Products 8K Bytes of In-System Reprogrammable Flash Memory. AT89CPC Microchip Technology / Atmel 8-bit Microcontrollers – MCU 8K Flash 24M datasheet, inventory, & pricing.

Author: Meztigal Kajitaxe
Country: Madagascar
Language: English (Spanish)
Genre: Technology
Published (Last): 1 September 2007
Pages: 264
PDF File Size: 12.14 Mb
ePub File Size: 5.31 Mb
ISBN: 413-4-43991-439-1
Downloads: 4504
Price: Free* [*Free Regsitration Required]
Uploader: Vozilkree

No program lock features.

Setting at89c2 ALE-disable bit has no. It is possible to use Timer 2. In the Counter function, the register is incremented in. Reading the Signature Bytes The signature bytes are. To eliminate the possibility of. Timer 2 interrupt enable bit.

The idle mode can be terminated by any enabled.

AT89C52 | 89C52 Microcontroller Datasheet & Pin Description

Timer 2 Output Enable bit. This bit can then be used to generate an interrupt. Timer 0 and 1. V CC program enable signal. Input the desired memory location on the address. Flash programming and verification. In addition, the AT89C52 is designed with static logic.



A logic 0 at T2EX makes Timer 2 count down. Serial Port interrupt enable bit. This overflow also causes the bit value in. Please contact your local. To program the AT89C52, take the. In this application, Port 2 uses strong internal pul. That means the upper Instructions that use indirect addressing access the upper.

Timer 0 and Timer 1 in the AT89C52 operate the same way. This pin also receives the volt programming enable volt. If the at89c5 is pow. User software should not write 1s to these. In this mode, two options are selected by bit.

Lock Bit Protection Modes.

Microchip Tech AT89CJC – PDF Datasheet – ATMEL & AVR In Stock |

Flash array or the lock bits. It can b e. Timer function, the TL2 register is incremented every.

The AT89C52 has a total of six interrupt vectors: In the power-down mode, the oscillator is stopped, and the. In this function, the external input is sampled.


AT89C52 Microcontroller

In that case, the reset or inactive values of. In addition, the transition at T2EX. Note, however, that one ALE. Program Store Enable is the read strobe to external pro. To program datasbeet non.

When set, allows a capture or reload to occur as a result of a negative transition on T2EX. EA must be strapped to GND in. There are no requirements on the duty cycle of the external.