– wiring (Denso) for Wingroad with Y12, Electrics. Frame / Series, Y12 / Y12, body, W (wagon), engine, HR15DE (HR15DE engine), drive, 2WD. HR15DE engine model. flexible wires and anchors, work properly. If loose parts, deterioration, cuts .. to any components or wiring of the supple- mental air . HR15DE engine torque curve. Achieves plentiful low-end torque extending through mid-to-high engine speed. MR20DE engine torque curve. liter engine.
|Published (Last):||20 November 2015|
|PDF File Size:||1.20 Mb|
|ePub File Size:||4.11 Mb|
|Price:||Free* [*Free Regsitration Required]|
You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use. Revving engine from idle to 3, rpm quickly after the following conditions are met – Engine: OFF Air conditioner switch: ECM is located in the engine room left side near battery.
After warming up, idle the engine Accelerator pedal: A few seconds after turning ignition switch OFF [Ignition switch: When ECM detects the throttle valve is stuck open: When electric throttle control actuator does not function properly due to the return spring malfunction: OFF] — — [Engine is running]?
This licensing tag was added to this file as part of the GFDL licensing update. ON] O — — — [Ignition switch: Fully released Clutch pedal: If the file has been modified from its original state, some details such as the timestamp may not fully reflect those of the original file.
Thus, they differ from ECM terminals wirinv signal. Before measuring the terminal voltage, confirm that the battery is fully charged. The fail safe function also operates when above diagnoses except MI circuit are detected and demands the driver to repair the malfunction. After warming up, idle the engine? No load Not used.
Fully released [Ignition switch: Engine running or cranking? Retrieved from ” https: After warming up, idle the engine More than seconds after starting engine?
Idle air volume learning has not been performed yet. Idle air volume learning has already been performed successfully. More than 1 second after turning ignition switch ON [Engine is running] [Ignition switch: Exhaust valve timing control does not function. ECM controls the electric throttle actuator hr51de regulating the throttle opening around the idle position.
Adjust ignition timing with a timing light before monitoring IGN TIMING, because the monitor may show the specification data in spite of the ignition timing not being adjusted to the specification data. Under the following conditions?
The item is indicated, but not used. After warming up, idle the engine Heater fan switch: Power generation voltage variable control: Fully released Brake pedal: You may select the license of your choice. Fully depressed [Ignition switch: Engine stopped [Engine is running]? The following other wikis use this file: The timestamp is only as accurate as the clock in the camera, and it may be completely wrong.
ON] — [Ignition switch: ECM controls the electric throttle control actuator by regulating the throttle opening to 20 degrees or less. P er Bank 1 High Input: The engine speed will not rise more than 2, rpm.
Specification data are reference values. Specification data are reference values and are measured between each terminals.
Engine is revving from idle to about 4, rpm — 0. After warning up, idle the engine? When ECM calculation function is malfunctioning: Therefore, when electrical controlled throttle and part of ECM related diagnoses are continuously detected as NG for 5 trips, ECM warns the driver that engine control system malfunctions and MI circuit is open by means of operating fail safe function.